TIPS & TRICKS August

Did you know that you can easily re-scan a single die AFTER you finish scanning the whole case?

Want to improve your scan of a specific die after scanning all dies in the case? Maybe a bubble, or another flaw in the physical model/die, shows up in a critical area and you want to manually repair the die and rescan it. This is especially useful if you applied multi-die scanning and want to avoid starting all over with a new multi-die scan.  

Step 1:
After scanning all the dies in the order, you will see the following message:

tips august 2013

Step 2:
To rescan a single die – click on the corresponding tooth in the case overview.

Step 3:
Press the Scan tooth button.  

That's all:

Yes, it's that simple…!

This tip can be a real time-saver in busy labs.

This website uses cookies

We use cookies (incl. 3rd party cookies) to improve the experience and performance of the website. We use them for statistics, remembering your preferences, and marketing purposes, including retargeting. You accept this when using this website. Read our Cookies Policy for more information
You're about to get redirectedWe are renovating our website, so you will see a different layout in the page you requested. Do you want to continue?