TIPS & TRICKS August

Did you know that you can easily rescan a single die AFTER you finish scanning the whole case?

Want to improve your scan of a specific die after scanning all dies in the case?Maybe a bubble, or other flaw in the physical model/die, shows up in a critical area and you want to manually repair the die and rescan it.This is especially useful if you applied multi-die scanning and want to avoid starting all over with a new multi-die scan. 

Step 1:
After scanning all the dies in the order, you will see the following message:

tipsaugust20132jpg

Step 2:
To rescan a single die – click on the corresponding tooth in the case overview.

Step 3:
Press the Scan tooth button.  

Thats all:

Yes, its that simple…!

This tip can be a real time-saver in busy labs.

返回至新闻