Tips & Tricks August
Did you know that you can easily rescan a single die AFTER you finish scanning the whole case?
Want to improve your scan of a specific die after scanning all dies in the case? Maybe a bubble, or other flaw in the physical model/die, shows up in a critical area and you want to manually repair the die and rescan it. This is especially useful if you applied multi-die scanning and want to avoid starting all over with a new multi-die scan.
After scanning all the dies in the order, you will see the following message:
To rescan a single die – click on the corresponding tooth in the case overview.
Press the Scan tooth button.
Yes, its that simple…!
This tip can be a real time-saver in busy labs.